Orbisphere 3600 series - 1.6 Spare Parts and Diagrams

34 3600 Analyzer for O
2
Measurement—Operator’s Manual
3600O2.OM.E9903
1.6 Spare Parts
Your recharge kit should contain sufficient material for several years of sensor
servicing. However, it will need to be replenished in time. What follows are
materials you will be likely to require. Be sure to mention the model number and
item description when ordering. (Note that there is an exploded sensor diagram in
the following section, with protection cap components identified.)
Model number Description
28083 LEMO-6 pin connector
28084 LEMO-10 female connector for extension cable
28085 LEMO-10 male connector for extension cables
28088 LEMO-10 connector for panel mount
28113 Membrane mounting tool (2 pcs)
28210 LEMO-8 pin connector
29006.0 EPDM O-rings for 32001 flow chamber
29501 Sensor socket for welding to SS pipe
2959 Electrolyte for sensor
2961 Electrolyte for sensor, H
2
S insensitive
2978 Polishing powder and cloth
32001.010 Flow chamber, SS, 6-mm fittings, EPDM O-rings
32001.011 Flow chamber, SS, ¼-in. fittings, EPDM O-rings
32001.030 Flow chamber, Delrin, 6-mm fittings, EPDM O-rings
32001.031 Flow chamber, Delrin, ¼-in. fittings, EPDM O-rings
32002.010 Multi-parameter flow chamber, SS, 6-mm connections, EPDM O-rings
32002.011 Multi-parameter flow chamber, SS, ¼-in. connections, EPDM O-rings
32205 Sensor support (base) for 31xxx sensors
32537 RS-232 cable, with LEMO-6 and 9-pin D-type connectors
32701 Recharge kit, 2935A membrane
32702 Recharge kit, 2952A membrane
32703 Recharge kit, 2956A membrane
32704 Recharge kit, 2958A membrane
32705 Recharge kit, 29521A membrane
32706 Recharge kit, 29552 membrane
32707 Recharge kit, 2995A membrane
32750 Battery, type G-1600CS, nickel-cadmium, 1.6 A/hr, 5 x 1.2 V cells
Contents of Recharge Kit:
Model number Description
2956A, 2952A, 29552A, 2958A,
2995A, 2935A, 29521A
Membranes (alternatives available)
29026A, 29027A Masks (optional)
2959 Electrolyte
2978 Polishing powder and cloth
29228, 29229 Membrane holding ring (model depends on membrane)
29039.0 EPDM O-ring
28504 Tool for tightening protection cap
28116 Tool for removing membrane holding ring
28114 Tool for removing membrane support
28113 Membrane mounting tool
Syringe and Tweezers