Orbisphere 3600 series - Program Flow Charts

3600 Analyzer for O
2
Measurement—Operator’s Manual 9
3600O2.OM.E9903
1.3.1 Program Flow Charts
The following flow chart depicts the menus you encounter when the instrument is
first turned on, and an overview of the menu choices. The Measure menu is
described further in section 1.3.2. The Calibration menus depicted below are
described further in section 1.3.3. The Modify Options menus are described in
more detail in section 1.4.
The flow lines are keyed to specific instrument actions. Note that when more than
one item is available within the same menu, the chart uses ellipses (“. . .”) to show
that there are more choices to follow (but you will not see the ellipses on screen).
You may highlight any one of these choices by pressing “ñ” or “ò”.
MEASURE OPTIONS
CALIBRATE
CALIBRATION
IN AIR
(See section 1.6 for
Modify Options menus)
O2 = 7.024 pmv 3
T = 22.3 °C
METHOD
TWO POINTS
V.32603-05.X
18/2/98
Main Menu
CALIBRATION
DIRECT
Calibration
Menu
Change range
CALIBRATION
BAROM. PRESSURE
MODIFY OPTIONS
DISPLAY UNITS
CALIBRATION
EXTERN. PRESSURE
NOW XXX% OF
LAST CALIBRATION
CALIBRATION
OUT OF BOUNDS
CALIBRATION
COMPLETE
NOW XXX% OF
EXPECTED CURRENT
CALIBRATION 0000
CONDITION ^
CC = 8.123 pmv 3
UP/DOWN MODIFIES
NOW XXX% OF
LAST CALIBRATION
CALIBRATION
OUT OF BOUNDS
CALIBRATION
COMPLETE
NOW XXX% OF
EXPECTED CURRENT
PRESSURE
XXXX mbar
BAROMETRIC 0000
PRESSURE ^
after
first calibration
CURRENT
XX.XX nA
EXTERN. PRESSURE
XXXX mbar
LOW POINT 0000
bar ^
CALIBRATION
PURE HYDROGEN
NOW XXX % OF
LAST CALIBRATION
H2 PRESSURE 0000
(CAL) mbar ^
available as
option 32646.E
METHOD
DEFAULT
after
first calibration
METHOD
ONE POINT
Options Menu
ONE POINT 0000
mbar ^
PRESSURE SENSOR
50 psia
HIGH POINT 0000
bar ^
after first calibration
AUTOMATIC (no keystroke required)
ESC
UP/DOWN
ENTER