3600 Analyzer for O
2
Measurement—Operator’s Manual 39
3600O2.OM.E9903
Next, check that you have set the acquisition rate to a convenient interval. Do this
by choosing Data Acquisition from the Configuration menu. This box appears:
The “All data” choice enables the program to accept measurements every four
seconds, the fastest rate available from the instrument. The longest interval is one
hour. Choose OK when you have the rate you require.
Finally, make sure you have chosen the proper gas to measure from the Gas
Selection menu under Configuration.
1.7.4 Acquiring Data
To commence data acquisition, while the instrument is making measurements,
choose Go from the Terminal menu.
You can expect to see a running display like the following:
The number of samples in the buffer will continue to rise until you choose End
from the Terminal menu, or when the limit of 2,000 samples has been reached.
To Next Page
Loading...