36 3600 Analyzer for O
2
Measurement—Operator’s Manual
3600O2.OM.E9903
Position Reorder Number Description
1 LEMO-10 connector
2 32502.mm (3600 series)
32506.03 (3600M series)
Sensor cable, 2 connectors (“mm” = length, standard
length 3 meters)
3 28104 Sensor collar, stainless steel
4 Sensor handle
5 29039.0 Sensor head O-ring (see also Kits below)
6 Sensor head
7 2952A, 2956A, 2958A,
29552A, 2995A,2935A,
29521A
Membrane (model depends on application)
8 29026A
29027A
Tedlar mask
Saran mask
9 29228
29229
29231
Membrane holding ring, for membranes
2956A, 2952A, 2995A, 2935A
Membrane holding ring, membrane 29552 or 2958A, or
for combination of mask (29026A or 29027A) and
membrane 2956A, 2952A, 2995A or 2935A
Membrane holding ring for membrane 29521A
10 28003 Silicone washer (see also Kits below)
11 29049 Dacron mesh (see also Kits below)
12 29060 0.20 mm grill (see also Kits below)
13 28002 Tefzel washers (see also Kits below)
14 29104 Standard protection cap
15 28504 Wrench for protection cap
16 29031A Water separation filter (see also Kits below)
17 29107 Protection cap for moist gases
18 29106 Protection cap for liquids and dry gases
(Note that the Tefzel washers are clearer and thinner than the Silicone washers are, and twice as
many Tefzel washers are supplied in a kit.)
Protection Cap Kits Available:
29046 28002 washers, 29060 grill, 29049 meshes, 28003 washers, and 29039.0 O-ring for
protection cap 29106
29054 28002 washers, 28003 washers, and 29039.0 O-ring for protection cap 29104
29063 28002 washers, 29060 grill, 28003 washers, 29031A, water separation filters, and
29039.0 O-ring for protection cap 29107
To Next Page
Loading...