Installation
16
5 Installation
5-1 Installation location
The motor and driver are designed and manufactured to be incorporated in equipment. Install them in a well-
ventilated location that provides easy access for inspection. The location must also satisfy the following conditions:
•
Inside an enclosure that is installed indoors (provide vent holes)
•
Operating ambient temperature: 0 to +40 °C [+32 to +104 °F] (non-freezing)
•
Operating ambient humidity: 85% or less (non-condensing)
•
Area free of explosive atmosphere, toxic gas (such as sulfuric gas), or liquid
•
Area not exposed to direct sun
•
Area free of excessive amount of dust, iron particles or the like
•
Area not subject to splashing water (rain, water droplets), oil (oil droplets) or other liquids
•
Area free of excessive salt
•
Area not subject to continuous vibration or excessive shocks
•
Area free of excessive electromagnetic noise (from welders, power machinery, etc.)
•
Area free of radioactive materials, magnetic elds or vacuum
•
Up to 1000 m (3300 ft.) above sea level
5-2 How to Install the motor
Combination type-parallel shaft gearhead
Secure the motor and gearhead through four mounting holes using the included mounting screw set.
Install so that there is no gap between the product and the mounting plate.
head screw
Plain washer
Spring washer
(L2)
L1
Model Gear ratio
Hexagonal socket head screw
(Material: Stainless steel)
L2 [mm (in.)]
Tightening torque
[N·m (lb-in)]
Screw size L1 [mm (in.)]
BLMR5100
10
to
20
M8
70 (2.76) 11.5 (0.45)
12.0 (106)
30
to
100
85 (3.35) 13.5 (0.53)
BLMR6200
10
to
20
85 (3.35) 11 (0.43)
30
,
50
100 (3.94) 14 (0.55)
100
110 (4.33) 10 (0.39)
To Next Page
Loading...
