Inspection and maintenance
41
8 Inspection and maintenance
8-1 Inspection
It is recommended that periodic inspections are conducted for the items listed below after each operation of the
motor. If an abnormality is generated, discontinue any use and contact your nearest Oriental Motor sales oce.
Inspection item
z
Motor
•
Check if any of the mounting screws of the motor and gearhead is loose.
•
Check if the bearing part (ball bearings) of the motor generates unusual noises.
•
Check if the bearing part (ball bearings) or gear meshing part of the gearhead generates unusual noises.
•
Check if the output shaft of the motor and gearhead and a load shaft are out of alignment.
•
Check if a damage or stress is applied on the cable or the connection part between the cable and driver is loose.
z
Driver
•
Check if any of the mounting screws secured the driver is loose.
•
Check if the connection part with the connector is loose.
•
Check if dust is deposited on the driver.
•
Check if the driver has unusual smells or appearance defects.
The driver uses semiconductor components. Static electricity may damage the semiconductor components of the
driver, so be extremely careful when handling them.
8-2 Warranty
Product warranty
Check on the Oriental Motor Website for the product warranty.
8-3 Disposal
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.
To Next Page
Loading...
