Installation
23
Combination type-hollow shaft at gearhead
10 mm (0.39 in.)
20 mm (0.79 in.)
Distance from mounting surface
Axial load
Radial load
Model
Permissible radial load [N (lb.)]
∗
Distance from gearhead mounting surface
Permissible axial load
[N (lb.)]
Gear ratio 10 mm (0.39 in.) 20 mm (0.79 in.)
BLMR5100
10
900 (200) [820 (184)] 770 (173) [700 (157)]
500 (112)
15
,
20
1300 (290) [1200 (270)] 1110 (240) [1020 (220)]
30
to
200
1500 (330) [1400 (310)] 1280 (280) [1200 (270)]
BLMR6200
10
1230 (270) [1130 (250)] 1070 (240) [990 (200)]
800 (180)
15
,
20
1680 (370) [1550 (340)] 1470 (330) [1360 (300)]
30
to
100
2040 (450) [1900 (420)] 1780 (400) [1660 (370)]
* The values assume a rated speed of 3000 r/min or below. The values in brackets [ ] are based on a rated speed of
4000 r/min.
5-5 How to install the driver
The driver can be installed in any direction.
Install the driver to a at metal plate* oering high heat conductivity.
When installing the driver, use the mounting holes and secure to the metal plate with two screws (M4: not included).
* Material: Aluminum, size: 200×200×2 mm (7.87×7.87×0.08 in.) or equivalent
Metal plate
Size: M4
Screw length: 15 mm (0.59 in.) or mor
•
Install the driver in an enclosure.
•
Do not install any equipment that generates a large amount of heat or noise near the driver.
•
Do not install the driver underneath a host controller or other equipment vulnerable to heat.
•
If the ambient temperature of the driver exceeds the upper limit of the operating ambient temperature,
reconsider the ventilation condition or forcibly cool the area around the driver using a fan in order to keep
within the operating ambient temperature.
To Next Page
Loading...
