Oriental motor BLV Series - Connecting the Motor and Driver

Connection
25
6-2 Connecting the main power supply (CN1)
The power supply current capacity varies depending on the motor connected.
Insert the connector of the power supply cable into the main power supply connector (CN1) on the driver.
The power supply cable
LC03D06A
(sold separately) is provided.
Motor Input power supply voltage Power supply current capacity
100 W
24 VDC 10 A or more
48 VDC 5 A or more
200 W
24 VDC 18 A or more
48 VDC 9 A or more
•
When connecting, pay attention to the polarity of the power supply. Connection with incorrect polarity may
cause damage to the driver.
•
Do not wire the power supply cable in the same cable duct with other power line or motor cable.

Pin assignment
Pin No. Name Description
1
2
3
Connector: F32FSS-03V-KX (J.S.T. Mfg. Co., Ltd.)
Contact: LF3F-41GF-P2.0 (J.S.T. Mfg. Co., Ltd.)
Designated crimp tool: YRF-880
(J.S.T. Mfg. Co., Ltd.)
1 VIN
Main power supply input
(24 to 48 VDC)
2 GND
Ground for main power
supply
3 FG Frame ground

How to wire the connector
•
Applicable lead wire: AWG18 to AWG16 (0.75 to 1.25 mm
2
)
1. Strip the insulation of the lead wires.
2. Crimp the lead wires and contacts using the
designated crimp tool.
3. Insert the lead wires that have crimped contacts
into the connector for CN1.
The input current varies depending on the main power supply voltage or the motor output power.
Select a wire diameter suitable to the input current.
6-3 Connecting the motor and the driver (CN2, CN3)
Insert the connectors of the motor cable into the motor connector (CN2) and the encoder/electromagnetic brake
connector (CN3) on the driver.
When extending the motor cable, use a connection cable (sold separately).
The maximum extension distance including the cable length of the motor itself should be 3.5 m (11.5 ft.).
•
Make sure to insert the connector securely. Insecure connector connections may cause malfunction or damage
to the motor or the driver.
•
Be sure to insert and pull out the connector while holding the connector part. Do not apply any force in a
direction other than the direction of inserting and pulling out the connector. Applying improper force may
cause damage to the connector and the driver.