Oriental motor BLV Series - Using the Unit Information Monitor

Appendix
44
9-3 Specications

Specications
Motor models in the table below describe a part of the entire name of models. Refer to p.12 for models in details.
Model
Motor
BLMR5100K BLMR5200K
/
BLMR6200SK
Driver
BLVD-KRD
Rated output power (Continuous) 100 W 200 W
Power supply
input
Rated voltage 24 to 48 VDC
Allowable operating
voltage
15 to 55 VDC
Rated current 2.6 A (48 VDC) to 5.1 A (24 VDC) 5.3 A (48 VDC) to 10.5 A (24 VDC)
Maximum input
current
10 A 18 A
Power supply
input for
communication
Rated voltage 24 to 48 VDC
Allowable operating
voltage
15 to 55 VDC
Maximum input
current
0.2 A
I/O signals
Input signal 12 to 30 VDC
Output signals 12 to 30 VDC Current 10 mA or less
Rated torque 0.319 N·m (2.8 lb-in) 0.637 N·m (5.6 lb-in)
Peak torque 0.704 N·m (6.2 ib-in) [220%] 1.34 N·m (11.8 lb-in) [210%]
Rated speed 3000 r/min
Speed control range 1 to 4000 r/min (Speed ratio 1:4000)

General specications
Degree of protection Motor: IP40, driver: IP20
Operating
environment
Ambient
temperature
0 to +40 °C (+32 to +104 °F) (non-freezing)
Humidity 85% or less (non-condensing)
Altitude Up to 1000 m (3300 ft.) above sea level
Surrounding
atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or other special
environments.
Vibration
Not subject to continuous vibration or excessive impact. In conformance with
JIS C 60068-2-6 "Sine-wave vibration test method"
Frequency range: 10 Hz to 55 Hz Pulsating amplitude: 0.15 mm (0.006 in.)
Sweep direction: 3 directions (X, Y, Z) Number of sweeps: 20 times
Storage
environment
Shipping
environment
Ambient
temperature
Motor: −20 to +70 °C [−4 to +158 °F] (non-freezing)
Driver: −25 to +70 °C [−13 to +158 °F] (non-freezing)
Humidity 85% or less (non-condensing)
Altitude Up to 3000 m (10000 ft.) above sea level
Surrounding
atmosphere
No corrosive gas, dust, water or oil.
Cannot be used in radioactive materials, magnetic eld, vacuum or other special
environments.