Installation
18
Combination type-hollow shaft at gearhead
A combination type-hollow shaft at gearhead can be installed by using either its front or rear side as the mounting
surface.
Using the included mounting screw set, secure through the four mounting holes so that there is no gap between the
product and the mounting plate. Nuts are not included with the 200 W type. Provide nuts separately or drill tapped
holes in the mounting plate.
Attach the included safety cover to the hollow output shaft on the end opposite from the one where the load shaft is
installed.
Mounting plate
Motor
Model
Hexagonal socket head screw
(Material: Carbon steel)
L2 [mm (in.)]
Tightening torque
[N·m (lb-in)]
Screw size L1 [mm (in.)]
BLMR5100
M8
90 (3.54) 21 (0.83)
15.5 (137)
BLMR6200
100 (3.94) 13 (0.51)
z
Using the front side as the mounting surface
When the gearhead is installed using its front side as the mounting surface, use the mounting boss of the output
shaft to align the center axes of the hollow shaft and the load shaft.
Hexagonal socket head screw
Mounting plate
Plain washer
Nut
z
Using the rear side as the mounting surface
Hexagonal socket head screw
Mounting plate
Plain washer
Nut
To Next Page
Loading...
