Oriental motor BLV Series - Page 28

Connection
28

Connection example with a current sink output circuit
IN3 (FREE)
IN2 (STOP)
IN1 (ID-SEL1)
IN0 (ID-SEL0)
IN-COM
15
16
17
18
19
6.6 kΩ 10 kΩ
6.6 kΩ 10 kΩ
6.6 kΩ
10 kΩ
6.6 kΩ 10 kΩ
DriverHost controller
0 V
1
2
3
4
OUT0 (COMM-PWR)
OUT1 (ALM-B)
12 to 30 VDC
0 V
10 mA or less→
R0
R0
12 to 30 VDC
* Values in parentheses ( ) are initial values.

Connection example with a current source output circuit
IN3 (FREE)
IN2 (STOP)
IN1 (ID-SEL1)
IN0 (ID-SEL0)
IN-COM
15
16
17
18
19
6.6 kΩ 10 kΩ
6.6 kΩ 10 kΩ
6.6 kΩ
10 kΩ
6.6 kΩ 10 kΩ
DriverHost controller
1
2
3
4
OUT0 (COMM-PWR)
OUT1 (ALM-B)
12 to 30 VDC
0 V
10 mA or less→
R0
R0
12 to 30 VDC
0 V
* Values in parentheses ( ) are initial values.
•
Use input signals at 12 to 30 VDC.
•
Use output signals at 12 to 30 VDC, 10 mA or less. If the current exceeds 10 mA, connect an external resistor R0
so that the current becomes 10 mA or less.
•
The saturated voltage of output signals is 2.0 VDC maximum.