Oriental motor BLV Series - Page 38

Guidance
38
STEP 4 Check of communication parameters
Start "Starts the simple setting." of the support software.
Set the following communication parameters according to the communication parameters of the host controller.
If the values are dierent, change the value of the "Input value" and execute "Reecting on the driver."
If the following communication parameters are dierent from those of the host controller, execute "Detailed setting..."
to change the parameters.
Parameter name Initial value
Byte & word order (Modbus) Even Address-High Word & Big-Endian
Communication stop bit (Modbus) 1 bit
The "Slave address" can be changed by the ID-SEL0 and ID-SEL1 inputs.