1.
Network connector
The PTZ Camera series connects to the network via a standard network cable,
and automatically detects
the speed of the local network segment (10BaseT/100BaseTX Ethernet).
This socket must be used to
power the PTZ Camera series via Power over Ethernet (PoE).
The camera auto-senses the correct power level
when using a PoE(IEEE802.3at) switch, router or injector.
*A ferrite core accessory is included to be used when connecting the network cable in order to suppress
electromagnetic waves.
2.
Audio in
Audio in (line level), for line-in mono signal (only left channel is used from a stereo signal)
3.
Audio out
The Audio output (line level), which could be connected to a line output of an active speaker with a built-in
amplifier.
4.
Power Connector
24VAC power connector
5.
Alarm out
Two relay output (2A: AC120V
/
DC24V)
COM (Alarm Out 2)
Alarm Out 2
COM (Alarm Out 1)
Alarm Out 1
6.
Alarm In
Two analog (dry contact) alarm input
COM (Alarm In 2)
Alarm In 2
COM (Alarm In 1)
Alarm In 1
To Next Page
Loading...
