EasyManuals Logo

ORTEC Detective-EX-100T User Manual

Default Icon
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
ORTEC
®
Detective-EX/DX
®
-100T Portable HPGe Spectrometer — User’s Manual 931040P / 1014
16
2.5. The Automobile Accessory Adapter
The Detective-EX is supplied with two automobile accessory adapters for use with a 12 V bat-
tery. One attaches to the POWER IN connector on either the docking station or the PAC-II, both
operating the Detective-EX and charging its internal battery. The other attaches to the Detec-
tive-EX’s rear-panel INPUT POWER connector and operates the Detective-EX but does not
charge the internal battery.
NOTE If the detector is warm, the power required to cool the detector can significantly
discharge a standard automobile battery.
To use an adapter cable:
! Plug the adapter end into a 12-V auto-mobile accessory socket.
! Connect the cable to the appropriate connector. If using the adapter cable that connects to
the docking station or PAC-II, plug it into the charger base’s POWER IN connector. The
internal battery will begin charging; if completely discharged, it will typically reach full
charge in 3–4 hours.
If using the adapter cable that connects directly to the Detective-EX, unscrew the dust
cap from the INPUT POWER connector on the rear panel; slide the coupling ring on the
male (cable-end) connector fully open; align the 5 keys on the male connector with the
slots on the rear-panel female connector; press to fully seat the male connector, then hold
it in place; and rotate the coupling ring approximately 1/8th of a turn clockwise until it
seats securely.
2.6. Internal and External Power
The Detective-EX uses power in these ways:
! The internal battery provides approximately 3 hours of operation. The internal battery
cannot be used to start the cooler or cool the detector from room-temperature; external
power is required. The transition from internal to external power is automatic and does
not interfere with data collection. Cooler startup without external power cause opera-
tional anomalies; these are discussed in troubleshooting Sections 7.5 and 7.6. An
exhausted internal battery should be charged for 2 hours before the Detective-EX is
cooled using external power.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ORTEC Detective-EX-100T and is the answer not in the manual?

ORTEC Detective-EX-100T Specifications

General IconGeneral
BrandORTEC
ModelDetective-EX-100T
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals