931040P / 1014 5. ADVANCED SETUP
53
Figure 47. View the Radionuclide
Library.
5.1.6.1. Viewing Stored Spectra
To display a particular spectrum file, tap the filename, then tap Choose. The histogram will be
displayed along with the filename, as shown in Fig. 49. The spectrum display controls are
discussed on page 35. To view the associated reports, see the next section.
5.1.6.2. Viewing Stored Spectrum Reports
Identification Mode spectrum files include both the spectrum and information on the radio-
nuclides found during the identification session. When you display a stored spectrum, you can
view this information by tapping the ID button below the spectrum display. This will open the
ID Report screen (Fig. 50). Tap the listbox at the top of the screen to access the list of Found
Nuclides (Fig. 51), Suspect Nuclides (for LCX Mode spectra only; Fig. 52), Top Lines
(Fig. 53), and GPS (Fig. 54); some of the reports may contain no entries. Tap Back to return to
Advanced Setup.
Figure 46. Collect Background for
At Least the Specified Minimum
Time.
To Next Page
Loading...
Need help?
General
