Description
G66 Divides spline prolein two sections with a corner
G67 Divides spline prolein two sections with feed rate reduced at the corner.
G70 Programming in inches
G71 Programming in millimeters
G72 Point probing with probe tip radius compensation
G73 Hole probing with probe tip radius compensation
G74 Probing for theoretical deviation from a point without probe tip radius compensation
G78 Programming referred to the tool tip and motion referred to the machine zero
G79 Programming referred to axis home position
G80 Disable canned cycles
G81 Drilling cycle
G82 Spot-facing cycle
G83 Deep hole drilling cycle
G84 Tapping cycle
G85 Reaming cycle
G86 Boring cycle
G89 Boring cycle with dwell
G90 Absolute programming
G91 Incremental programming
G92 Axis pre-setting without mirror
G93 Inverse time (V/D) feed rate programming mode
G94 Feedrate programming in ipm or mmpm
G95 Feedrate programming in ipr or mmpr
G96 Constant surface speed (feet per minute or metres per minute)
G97 Spindle speed programming in rpm
G98 Axis pre-setting with mirror
G99 Delete G92 or G98
OPENcontrol Technical overview
27
To Next Page
Loading...