OSAI OPENcontrol - List of G-Codes

List of G-codes
Description
G00 Rapid axes positioning
G01 Linear interpolation
G02 Circular and helical interpolation CW
G03 Circular and helical interpolation CCW
G04 Dwell at end of block
G05 FeedHold at the end of the movement
G06 FeedHold at the beginning of the movement
G09 Deceleration at end of block
G10 Linear interpolation with rapid dynamic parameters.
G12 3D circular interpolation CW
G13 3D circular interpolation CCW
G14 3D circular interpolation using 3 points
G16 Circular interpolation and cutter diameter compensation on a user denedplane
G17 Circular interpolation and cutter diameter compensation on 1st-2nd axes plane
G18 Circular interpolation and cutter diameter compensation on 3rd-1st axes plane
G19 Circular interpolation and cutter diameter compensation on 2nd-3rd axes plane
G26 Continuous sequence with null feed at the end of block
G27 Continuous sequence operation with automatic speed reduction on corners
G28 Continuous sequence operation without speed reduction on corners
G29 Point-to-point operation
G31 Identies a movement that can be stopped with Active Reset
G33 Constant or variable pitch thread
G35 Absolute roto-translation of a linear axes tern
G36 Roto-translation on a linear axes tern towards the active origin.
G37 Coordinates of the teorethical points for the denition of the roto translation by three points
G38 Coordinates of the measured points for the denition of the roto-translation by three points
G39 Activation of rototranslation dened by three points
G40 Cutter diameter compensation disabled
G41 Cutter diameter compensation-tool left
G42 Cutter diameter compensation-tool right
G60 Closes spline prole (HSM)
G61 Opens spline prole (HSM)
G62 Divides spline prole in two continuous units
G63 Divides spline prole in two units with connector
Software Key Features
26