Osprey Talon User Guide
28
Enable (all formats)
For Web streaming, only 1 pair of audio inputs may be used at a time. Enable the input from “Sub
Channel 1” by selecting “yes”. Be certain that all of the remaining Sub Channels are disabled.
NOTE: Multiple Sub Channels are only used for UDP and MPTS streaming. They are not available for
RTMP or RTP.
Source (all formats)
Select from HD/SDI, HDMI, or Analog.
Codec (all formats)
For live streaming select from AACLC (low complexity) or AACHE (high efficiency). The audio codecs
labeled MPEG2 and MPEG1L2 are only used for MPEG2 TS streams.
Sample Rate (all formats)
Default sample rate is 48000 Hz. Occasionally 44100 Hz is used for older smartphones. Also available are
32000 Hz and 16000 Hz.
Bit Rate
Default bit rate is 96 Kbps. Select your preferred rate from the pull down menu.
Mode (all formats)
Select Stereo or Mono. Stereo is the default and preferred setting.
Rtp Port (RTP only)
Select the audio port for the RTP stream. Default setting is 8900, but any port can be selected. Common
usage is from 4000 to 40000.
Pid (UDP only)
Identifies the UDP Process ID for this port.
Max PTS-PCR (UDP only)
Sets the maximum deviation for Presentation Time Stamps and Clock
Reference in UDP and MPTS delivery. Default is 250.
Format
Values are ADTS and LATS. Use the default ADTS for RTMP streaming.
Jumbo PES
Enables Jumbo PES and allows specification of number of AUs. Default is None.
To Next Page
Loading...
Need help?
General
