ii) to add NI network device
a. device powering. To disconnect the USB communication between the device and target PC, with AC
adapter get through power source, then power the device, with indicator lights red for seconds.
b. WiFi communication. To communicate the device with target PC through WiFi hotspot set onto device, as
per correct SSID and Password.
- Note -
Provided not possible to auto-switch between WiFi and LAN connection onto target PC, disable LAN.
Dot-tick “Obtain an IP address automatically” for the IP address onto target PC, or use the same first 3
sections of IP address set as point b. under i) part, say, 192.168.100
c. choose NI Max from Windows Start menu.
d. following page comes,
via “Devices and Interfaces”, then “Network Devices”, enter into “Add Network Device”
To Next Page
Loading...
Need help?
General
