Owon AG4101 - To Output Pulse Signals

5.Front Panel Operation
Parameter bar
1
Symmetry
Input box
Current parameter
Symmetry
Figure 5-6: Set the symmetry of Ramp signal
To Output Pulse Signals
Press button to call the user interface of Pulse signal, the Pulse waveform
parameters can be set by operating the Pulse setting menu on the right.
The parameters of Pulse waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Pulse Width/Duty, Edge Time. You can operate the menu by using the
menu selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To
Output Sine Signals" on P11.
The frequency range is 1μHz～25MHz; the period range is 40ns～1Ms.
Parameter bar 1
Setting menu
of Pulse signal
Amplitude
Load
Offset
Parameter bar 2
Current signal
Edge time
Frequency
Current parameter
Pulse width
Figure 5-7: The User Interface of Pulse Signal
15