Owon AG4101 - To Output Arbitrary Signals; To Select the Built-In Waveform

5.Front Panel Operation
To Output Arbitrary Signals
Press button to call the user interface of Arbitrary signal, the Arbitrary waveform
parameters can be set by operating the Arbitrary setting menu on the right.
The menu items of Arbitrary waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Built-in Waveform, Editable Waveform. You can operate the menu by
using the menu selection buttons on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To
Output Sine Signals" on P11.
The frequency range is 1μHz～10MHz; the period range is 100ns～1Ms.
The Arbitrary signal consists of two types: the system built-in waveform and the
user-definable waveform.
Parameter bar 1
Setting menu of
Arbitrary signal
Amplitude
Load
Offset
Parameter bar 2
Current signal
Frequency
Current parameter
Built-in
Exponential Rise
Waveform
Figure 5-11: The User Interface of Arbitrary Signal
To Select the Built-in Waveform
There are 26 built-in Arbitrary waveforms.
Menu
Settings
Explanation
Common
StairD/StairU/StairUD/Trapezia/RoundHalf/
AbsSine/AbsSineHalf/SineTra/SineVer
Choose common Waveforms
Maths ExpRise/ExpFall/Sinc/Tan/Cot/Sqrt/x^2 Choose Math Waveforms
Window
Rectangle/Gauss/Hamming/Hann/Bartlett/
Blackman/Laylight
Choose Window Waveforms
Others DC/Heart/Round Choose other Waveforms
Back Back to the previous menu
Steps for selecting the built-in waveform:
18