Owon AG4101 - Page 48

9.Technical Specifications
Waveform Characteristic
Sine
Flatness (when the Amplitude is 1.0
Vp-p (+4 dBm), relative to 100 kHz)
<10 MHz: ±0.2 dB
10 MHz to 25 MHz: ±0.3 dB
25 MHz to 100 MHz: ±0.5 dB
100MHz to 150 MHz: ±1 dB
Harmonic Distortion (when the
Amplitude is 1.0 Vp-p)
<-40 dBc
Total Harmonic Distortion (when
the Amplitude is 1 Vp-p)
10 Hz to 20 kHz: <0.2 %
Phase Noise (when the Amplitude is
1 Vp-p)
20 MHz: <10 kHz offset
-110 dBc/Hz (typical)
Residue Clock Noise
-57 dBm (typical)
Square
Rise/Fall Time
<10ns (10%
～
90%) (typical, 1kHz, 1Vpp)
Jitter (rms)
300ps + 100ppm of period (typical)
Non-symmetry (below 50% Duty
Cycle)
1% of period+ 5ns
Overshoot
< 2%
Duty Cycle
20% ~ 80% (to 25 MHz)
50% (> 25 MHz)
Pulse
Pulse Width
40 ns to 2000 s
Accuracy
1ns
Rising/Falling Edge Time
20 ns to 500us
Overshoot
< 2%
Jitter
300ps + 100ppm of the period
Ramp
Linearity
< 0.1% of peak output (typical, 1kHz, 1Vpp,
Symmetry 100%)
Symmetry
0% to 100%
Arbitrary
Waveform Length
2 ~ 1M points
Sample Rate
200MSa/s
Amplitude Accuracy
14 bits
Minimum Rise/Fall Time
35ns (typical)
Jitter (RMS)
6 ns + 30ppm
Modulated Waveform
AM
Carrier Waveforms
Sine
Source
Internal/ External
Internal Modulating Waveforms
Sine, Square, Ramp, White Noise, Arbitrary
43