Pacific Power Source UPC-32 - Page 53

SECTION 4 OPERATION
43
4.5.1.1 PROGRAM EXAMPLE (continued)
Press 108, ENTER, 108, ENTER, 108, ENTER, to select 108 volts line to neutral on all three phases.
PROGRAM: #4 FORM=3 COUPLING=DIRECT
FREQ=400 Va=108 Vb=108 Vc=108
WFa=1 WFb=1 WFc=1
#SEGS=0 Ilim=50 PHb=120° PHc=240°
Press 1, ENTER, 1, ENTER, 1, ENTER, to select WaveForm 1 on all three phases.
PROGRAM: #4 FORM=3 COUPLING=DIRECT
FREQ=400 Va=108 Vb=108 Vc=108
WFa=1 WFb=1 WFc=1
#SEGS=0 Ilim=50 PHb=120° PHc=240°
Press ENTER, 50, ENTER to set Ilim
If Current Protect has been activated (4.6.3.9), then, after setting Ilim:
Press CLEAR, CLEAR, +/- key to show IprA, press ENTER, value, ENTER to set IprA.
Press CLEAR, CLEAR, +/- key to show IprT, press ENTER, value, ENTER to set IprT
PROGRAM: #4 FORM=3 COUPLING=DIRECT
FREQ=400 Va=108 Vb=108 Vc=108
WFa=1 WFb=1 WFc=1
#SEGS=0 Ilim=50 PHb=120° PHc=240°
Press 120, ENTER, 240, ENTER, to select 120° phase shift for phase B and 240° phase shift for phase C
referenced to phase A.
PROGRAM: #4 FORM=3 COUPLING=DIRECT
FREQ=400 Va=108 Vb=108 Vc=108
WFa=1 WFb=1 WFc=1
#SEGS=0 Ilim=50 PHb=120° PHc=240
Press EXECUTE to execute this new program. The V/I METER display will become active.
V/I METER:
FREQ=400.0 Va=108.0 Vb=108.0 Vc=108.0
SENSE=INT Vab=187.1 Vbc=187.1 Vca=187.1
PROGRAM #4 Ia=00.0 Ib=00.0 Ic=00.0