MANAGER PROGRAMS Downline Programming
Downlining to a Single Workstation
At times, you may need to send program information to only one of the workstations on
your system. You can use the following procedure to send a file to a single workstation at
a time.
1. With your keylock in MGR Mode, enter the following sequence to advance the
screen to the Downline Program.
5 CASH 6 0 CASH
2. Enter the number of the workstation (terminal) you want to update.
3. Press TERM #.
[ workstation # ]
TERM
#
4. Choose the file you want to downline to the selected workstation by entering the
number listed to the left of the file you need to send.
5. Press CASH.
Note: Do not select the "All PLU" option without first reading the warnings in the PLU
Downlining procedures.
[ downline # ]
CASH
If your file selection is successfully downlined, its downline function number is
highlighted in reverse video.
6. Repeat steps 2 - 5 for each of the files you must send to this workstation.
7. To leave this program, press CASH twice to go back to the MGR Mode menu.
CASH CASH
5-80 Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
To Next Page