OPERATOR PROCEDURES Cover Count
Cover Count
The # GUEST or # COVERS key records the number of customers represented on an
order. Your program may require a count entry. If the entry is required, and you forget
it, an "Enter # of Guests" or similar message displays.
To record the count, enter the number of guests and press the # GUEST key.
[ # of guests ]
#
GUESTS
Your entry displays beside the table number, as shown below.
11:15 LVL1 REG
TABLE2 #GST2
#003 EAT IN
SAM
DAVE
Your entry displays beside the Table number.
Note: If your entry is too low, or if additional guests join the party before the transaction
is finalized, you can increase the guest count. Enter the new number of guests and
press the # GUEST key. If, for example, you start the check with two guests, and two
more guests join them, enter '4' and press the # GUESTS key.
2-8 Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
To Next Page