OPERATOR PROCEDURES Return
with the same sequence you originally used. If you are returning more than one item,
remember to press RETURN before each item.
Note: If "Call Manager" or a similar message displays, turn (or ask your manager to turn)
the keylock to MGR Mode before you attempt the return procedure. If you need to
perform a return outside of a transaction, you may need to press a destination key
(Eat-In, Take-Out, etc.) before you turn to MGR Mode.
RTRN
CHEF
SAL
The returned items display with a negative price. The appropriate taxes are also credited,
as shown in the example here.
1 CHEF SAL -7.95 11:15 LVL1 REG
TABLE #GST2
#003
TAX - .30
TOTL - 8.25
SAM
DAVE
Note: After you register the Return, you can continue with the transaction. You can add
new items, if necessary, or close the transaction with the procedures you normally
use.
Coupons
Each of your menu items can be linked to three different coupons. When you press one of
the coupon keys with an item, the system performs a look-up. It checks to see which
coupon is programmed for the item and automatically registers the amount. This look-up
process includes a procedure called "coupon search." Coupon Search helps ensure that you
have registered the item to which the coupon applies.
Two types of coupons are available: Preset Coupons and Open Coupons. Refer to the
procedure that applies to your transaction.
Preset Coupons
If your coupons are preset (programmed with a preset amount), use the following
procedure to register a coupon. Before you attempt to enter the coupon, however, make
sure you enter the item to which it applies.
2-28 Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
To Next Page
Loading...
Need help?
General
