Non-Sale Operations OPERATOR PROCEDURES
[ amount received ] →
CASH
[ amount received ]
CASH R/A
Paid-Out
You can use Paid-Out (P/O) to decrease the cash in your workstation drawer. You may
use Paid-Out when the amount of cash in your drawer exceeds the acceptable limit, or to
take money out of the drawer for a vendor payment. Two P/O keys are available.
Note: If MGR Mode is required for your P/O key, press EAT-IN or TAKE-OUT (or another
destination key) before you turn the keylock to MGR Mode. Then follow the steps
below.
1. Press P/O.
2. Enter the amount you need to remove from the drawer.
3. Press CASH.
4. Press P/O again. The amount you enter is subtracted from the CAID (Cash-in-
Drawer) total.
[ amount paid out ]
P/O CASH P/O
If you have multiple P/O entries, you can enter all of them at the same time.
1. Press the P/O key to start the procedure.
2. Enter the first amount.
3. Press CASH.
4. Enter the next amount.
Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0 2-55
To Next Page
Loading...
