MANAGER OPERATIONS X1 Mode Programs
Server Disable
Use X1 Mode Program 5 to help prevent unauthorized use of specific server numbers. The
numbers you enter in this program cannot be used for daily operations until they are re-
enabled. Use the following procedure to disable or enable a server number.
Note: This procedure disables the server number at the workstation where it is entered. If
you want to prevent use system-wide, you must repeat the procedure at each
workstation.
1. Turn the keylock to MGR Mode.
2. Select the X (& PRGM) option. Your screen displays the X1 Mode menu.
1 CASH
3. Select the Program option. Your screen displays a list of the available X1 Mode
programs.
5 CASH
4. Select the Server Disable program. If an "Enter Manager" message displays, you
must log on a valid manager number before you can continue. (See the Manager
Log-On procedure, described earlier in this manual.) The screen advances to the
Server Disable menu.
5 CASH
5. Enter the number of the server whose status you need to change. Your screen
advances to the menu shown on the next page.
[ server # ]
CSHR
4-38 Panasonic 5000 Version 4.0 Operating Instructions - Rev. 2.0
To Next Page