DBS
Programming Method
Chapter2 Programming Method
2 - 1 Preparing Programming Data Table
Before setting a program, the data
schedule is prepared. Hand the
questionnaire (found in the Section 450
programming table) about the
programming specifications for the
telephone to the customer and enter the
necessary functions and installation
specifications in the programming table
based on the details recorded therein.
SECTION 400 (Version 3.0)
Issue 1 January 1990
Cautions when Preparing Data Table
A Keep the trunk lines, extensions and
connected equipment not being used in the
initial set status without including them in
the programming.
B. Be sure to record the fact every time changes
are made to the programming data table.
This will be necessary in the future for
maintenance pur- poses and when extra
telephones and outside lines are added.
C The functions of those items marked by ** in
the
setting
data table cannot be set or
changed during operation. Do the
programming when the functions are no
longer being used.
71 1 Featurename_] Setting data number
Relate program
4
4
and initial data number
v
*
v
Address No. Feature Option selected Setting data Related setting
Fig, 2 - 1 Example of Section 450 Programming Table
-2-
To Next Page