SECTION 400 (Version 3.0)
Issue 1 January 1990
DBS
FF-1 System mode
Chapter 3 Programming Explanation
3
- 1 System (System kvotal prowam) mode
c---““““---“-“-“-“-““--““““------”~
: Construction of explanation is as follows.
I i
:
8
1
Title _.._ Introduce the title of each function. !
Address
I
:
.
I
I
number Describe the order of key press. i
I
I
I
: Contents Explanation setting data and
I
I.
I
specification.
:
I
:
:
I
:
Initial set indicatethe initial setting data with t
underline.
I
I I
:
I
,--““,,,,““““,,,-“,,,,,,,-----,----””~~”””””-~
3 - I- 1 Calendar and Time Setting mode
FFl-1 g-1 #( Month -Day- Year(Low 2 digits))
Date Setting
With this setting the date is stored in the clock
within the system.
The current day and date are displayed on
telephones equipped with LCD& while the date
and day are also recorded during SMDR printing,
etc. The day is automatically calculated and
displayed on the system.
MM (01-12)
DD (01-31)
YY (89-99) (00-20)
For aligning the time to February 251995, input
as follows
0225958
FF 1-l #-2f(Hour(24l+format) - Minute )#
Time Setting
With this setting the time is stored in the clock
within the system.
The current time is displayed on telephones
equipped with LCDs, while the time is also
recorded during SMDR printing, etc.
HH (00-23)
MM (00-59)
For aligning the time to 3:28pm, input as follows.
1 SZB#
fC0~Fl-#:01 :oi
3 - I- 2 System Program Setting mode
FFl-2#-I#-I#-(0 or l)#
Call duration display
The time a telephone conversation with an outside
line is taking can be displayed on a telephone
with an LCD. Whether or not this display is *
required is specified. If it is set 50
that
it is not
displayed, the conversation time for incoming
calls from when they are answered is not displayed
either.
0#: Telephone conversation time not displayed
l#z Telephone conversation time disolaved
FFl-2#-1#-2#-(0- l)#
SMDR Timer/ Starting time display for
outside call
In cases wherethe time taken for a outside call is
to be displayed, it is specified whether it will start
16 seconds or 30 seconds after the dialing signal
has been sent out.
This setting only functions if the outside call
duration display in l-2-1 has been specified.
This setting notwithstanding, for incoming calls
will start immediately, and display 16 seconds
after they are answered.
O#: Startina from 16 sec.
1#: Starting from 30 sec.
FFl-2#-I#-3#-(0 or I)#
LCR (Least Cost Routing) call
This is set for using the LCR call function. It is
specified whether or not LCR is to be used when
making an outside call by dial key 9.
In either case it is necessary to cut the jumper wire
on the CPU card in the main cabinet. See Section
300 the “Installation Manual” about this.
it is also necessary to set “FFZ-N+3#” and “Pooled
Trunk Access Group 9” of “2. Trunk Mode”.
OR: Pooled Trunk Access call when 9 keved in
l#: Least Cost Routing call when 9 keyed in
-1 l-
To Next Page