DBS
SECTION
400
(Version 3.0)
FF-1 System mode
Issue 1 January 1990
FFI-2C1#-4#(89 - OO)#
SSD (System Speed Dial) toil restriction
canceling (Override TRS)
It can be set so that calls from specified SSD
numbers are not restricted even
on
telephones
set fortoll restriction types from 2 to 6.
For example, it is set so that calls can be made
from telephones subjectto restrictions such as
those at distant branches, fire station, etc
When a 2 digit Auto-(00 - 89) number is stored for
the SSD code, when a call is made, from 89 to the
number stored are not restricted.
For example, when 80 is specified, calls can be
made with the 10 SSD codes comprising Auto-(80 -
89) despite restrictions.
(00 - 89)#: Calls can be made by SSD code 00 - 89
despite restrictions
jCONFJ-R: Toll restriction twes 2 - 6 also aoolied
durinaSSD calls
FFI- 2#- l#-S#-(O or l)#
Diai display restriction during system
speed dial call
lt is specified whether the telephone number is to
be indicated on the LCD during dialing when
making a call by SSD (80 - 89).
If set not to display, rediaiing after an SSD call and
diaiing with an LCR call are also not displayed.
However, the names stored for SSD are displayed
at such times.
O#: Dialino disolaved durina Autd80 - 89) call
18: Dialing not displayed during Auto-(80 - 89) call
Note: Auto (00 - 79) are displayed all the time.
FFl-2#-l#-6#-(0 - 1)#
Auto -flash redial
This setting is for automatically cutting of an
outside line by pressing the redial key after one or
more digits have been dialed and automatically
dialing the same number again.
In the case of the system is connected
to the
PBX,
sometimesthe PBX becomes on - hold status by
the operation of ‘Automatically cutting of an
outside line’ using Redial key.
Atthis time, Please set for “NO Auto Flash’
0#: No auto flash
l#: Auto flaih
Note I: When setting this function, check
that
it
is aligned with the setting for the
outside line ffash time as they
are
related.
Note 2: There is no flash if the dial is not input
.
-
FFl-2#-1#-8#-(0
or l)#
On-hook transfer
A outside call can be transferred to another
extension simply by pressing that extension’s
number and placing the handset on hook.
The party to which the call is being transferred
can talk with the party on the outside line simply
by lifting his/her handset when the incoming call
tone sounds.
If this is not set, see operating instructions to how
to transfer.
0#: On-hook transfer disable
I#: On-hook transfer enable
-12-
To Next Page