:
FFl-3#-19C(O- 15)#
Call forward No answer timer
If a call is not answered by an extension which has
call foward no answer set within the specified
ti’me period, the call will be diverted to a
predetermined extension. The call forward no
answer timer can be set from 4io 64 seconds. .
O#:Call forward after 4 Seconds
1 #Xall forward after 8 Seconds
_ Z#:Call forward after 12 Seconds
3$Kall forward after 16 Seconds
4#:Cail forward after 20 Seconds
S#:Call fomard after 24 Seconds
6#:cBll forward after 32 Seconds
7#:Call forward after 36 Seconds
S#:Call forward after 40 Seconds
9#:CaII forward after 44 Seconds
1 O#:Call forward after 52 Seconds
l
SECTION 400 (Version 3.0)
Issue 1 January 1990
3 -7 - 4 Remote
Maintenance Code mode
Ffl - 4#-(0000 - 9999)#
Storing the ID for remote maintenance
Remote controlled maintenance for the system
can be done through a telephone circuit An 4
digit code is stored for this purpose.
The system first automatically answers a call
coming in on the exclusive DISA line.
Then, after the intercom dialing tone has been
sent out by the system, the stored code is input
and the remote maintenance starts.
For actually effecting the remote maintenance, in
addition to this setting it is also necessary to store
the DISA code.
For remote maintenance 3 of the following
operations indicated are possible.
A: Remote programming:
Set remotely as with normal programming.
B: Program data list out:
The programmed data are checked when
irregularities in the operation occur.
c: System installation list:
The terminals connected to the system
togetherwith the types and number of
mounted cards are checked.
[CONF]#:
Clear to DATA (Initial = 9999)
(0000 - 9999)#: Remote maintenance can be done
according to stored code.
Note: To
l
nabie the use of the D&4 function it is
necessary to set the exclusive DISA line to
an outside line port separately.
-27-
To Next Page