DBS
FF-1 System mode
SECTION 400 (Version 3.0)
Issue 1 January 1990
3 - I - 5 DISA ID Code mode
FFl-5#-(0000 - 9999)#
DISA ID code storing
(Direct inward System Access)
Use of the DISA function allows for DID (Direct in
dialing) from outside’the system and DISA
outgoing call (making a call on a different line via
the system from outside).
If *is ID code is not set then system accept the
DISA call withoutthe input ID cod, It also enables
remote maintenance through a telephone circuit
by the installer of the system.
Forthese operations it is necessary to input the
exclusive DISA code followed by the remote
maintenance code, DISA outgoing call code, etc.
IC~NF~A: Clear data
(0000 - 9999)#: The DISA function can be used
according to the stored code.
Note: To enable the use of the DISA function
it
is
necessaty to set the exclusive DiSA line to
an outside line port separately.
3 - ? - 6 DISA Outqoinq Call ID mode
FFl-6#-I#-(0000 - 9999)C
DISA Outgoing call ID code 1 storing
By inputting the stored code when DISA is
operating, it is possible to make a call from a
different line via the system from outside.
For using this function an
code is stored.
[CONF]#:
Clearto data (Initial = 1111).
(0000- 9999)#: To enable the use of the DISA
function it is necessary to set the
excfusive DISA line to an outside
line port separately.
FFl-6#-Z#-(OOOO - 9999)#
DISA Outgoing call ID code.2 storing
By inputting the stored code when DISA is
operating, it is possible to make a call from a
different line via the system from outside. For
using this function an code is stored.
[CONF]#: Clear to data (Initial = 9999).
(0000- 9999)C: To enable the use of the DISA
function it is necessary to set the
exclusive DISA line to an outside
line port separately.
3 - I- 7 System proqram ID code mode
FFl-7#-(0000 - 9999)#
System programming ID code storing
Normally system programming is oniy possible
from the attendant’s phone.
But by inputting this code, the system can also be
programmed from another extension.
The code is stored for the system. As the program
is the most part of the system, always be sure to
record it in the setting table (Section 450) and pay
sufficient attention when dealing with the codes.
The codes already set can be deleted with the
[CONa key.
[CONF]#: Clear to data (Initial = 9999).
(0000 9999)#: System can be programmed
according to the stored code.
Note: Another extension telephone can’t program
before the extension telephone which
programmed cancel the programming mode.
-2%
To Next Page