DBS
FF-4 Ring mode
3 - 4 - 3 Hunting group setting mode
When there is an incoming call to a group for a
work unit within the company, if the extension
which has received it is busy, it is automatically
transferred to another extension in the group.
With this setting extensions are stored for each
hunting group number for allowing incoming calls
to be automa tically transferred between them
when they are busy.
-. For the registered extensions incoming calls are
transferred within the group according to the
order set
There are 8 hunting groups and up to 8 extensions
wn be stored in each group.
However, when the extension called is set for
absence transfer, the incoming call is transferred
to the other extension set regardless of the order
set in this program.
If an extension receiving a hunting group transfer
is set for absence transfer, absence or OND, it is no
longer available
and the
call is
transferred
to the
next extension within the group.
SECTION 400 (Version 3.0)
$K
4 $oy
Issue 1 January 1990, # &
Ce
FF4-3#+- 8)#-W-(1 - O)+
#$pJ( 4
Hunting group mode type
p” g t)(\i, 4:’
4+ v@,i@d+
When there is an incoming call to an extension
within the hunting group which is busy, it is
r(’
automatically transferred according to the order
laid down in the hunting group table.
-This setting is for specifying, if the last extension
stored in the table is also busy and cannot receive
the transferred call, whether the transfer process is
to be implemented once more from the first
extension in the table (hereafter called the circular
mode), dr in the cati
of
an incoming intercom call
on member 1 is transferred in order and when the
last extension is also busy and cannot receive the
transferred call whether to busy tone is to be sent
to the extension making the call and the transfer
process within the hunting group thereby
terminated (hereafter called the terminate mode).
This isthe same for incoming outside line calls
except that the busy tone is not sent out in this
case.
The incoming call tone is sent from the busy
extension which has received the call.
1 t-1 #-(0 - l)#: Call hunting group 1 is
(0: Terminal, 1: Circular)
2+-l #-(0 - l)%: Incoming call hunting group 2 is
(0: Terminal, 1: Circular)
3#-I#-(0 - I)#: incoming call hunting group 3 is
(0: Terminal, 1: Circular)
4#-l#-(O - l)#: Incoming call hunting group 4 is
5#-
6#-
7#-
8#-
1
(0: Terminal, 1: Circular)
#-(0 - l)#: Incoming call hunting group 5 is
(0: Terminal, 1: Circular)
#-(0 - l)#: Incoming call hunting group 6 is
(0: Terminal, 1: Circular)
f-(0- l)#: Incoming call hunting group 7 is
(0: Terminal, 1: Circular)
B-(0 - I)#: Incoming call hunting group 8 is
(0: Terminal, 1: Circular)
-48-
..-
/
i
i
‘\
To Next Page