SECTION 400 (Version 3.0)
Issue 1 January 1990
---de?
FFS-6&l %&-(I - 8)#- (l -32)#
Trunk Grotip Table Setting
When making an LCR call the line within the
cheapest trunk group table at the time of catling is
used.
There are a total of 8 trunk group tables in each of
which 8 lines can be set
The order of priority for a trunk group is
determined bythe time prioritytable.
There is also an order of priority for the lines
within each table so that they can be divided up
even more precisely.
Normally they are put together in trunk groups of
the same type as with MCI and SPRINT.
Trunk Group table
LCR trunk group
Data: Trunk port number (1 - 32)
l#(Croup 1): _ .
FF8-7#-(l- 8)#-(Max. 10 ‘digit numbers)#
Dial delete table storing
The numbers it is desired to delete from the heads
of the numbers input into each LCRtrunk group
are stored. Up to a maximum of 16 digits can be
deleted.
These digits are deleted from the heads of
numbers only when the dialed number and the
number stored correspond and are not dialed out
to the trunk line.
Numbers already stored are canceled by inputting
CONF.
LCRtrunk group number: 1#
(Dial delete number/Max 16 dioits)#
I (Special area code table number l-1 5)
LCR trunk group number: 8#
,#~22#~#~4#‘js#gC6#i7t8~~
2# (Group 2):
(Dial deiete number/Max 16 &its)++
,,6 2#3 3# 4# S# 6# 7# 88
NOTE:
--------
May not storing “* ” and “#“data, that
3# (Group 3):
even use rhq FFl 1 and FF72 keys.
l#-2#-3#4#-5#-6#7#-6#-
4# (Group 4):
1#2#3#4#-5#6f7~8#-
5# (Group 5):
1%2#3#4ff#-6#7#-8#-
6# (Group 6):
1#-2#-3#4#-5#6#7#-6#-
7# (Group 7):
1#2#3%48-5%6#7#-8#-
8# (Group 8):
I ~-2i~t3#4#-5#-6#7#-8#-
-71-
To Next Page
Loading...
