S-DBS Programming Instructions
v1.0
Section 400
Issue 1 July 1990
PROGRAMMING KEYS
HOLD
- Assigns data ~~advances-to-~~~~~er.- ..___
port at the same address.
FLBH
- Assigns data and returns to the previous
port at the same address.
#
*
AUTO
- Assigns data and advances to the next higher
address at the same port.
- Assigns data and returns to the previous
address at the same port.
- Moves to a higher or lower address at the
same port by pressing AUTO and entering the
new address.
CONF - Clears data
REDIAL - Resets data
VOL APROG - Moves to higher ports either assigning data
to a port or copying data from one port to
another.
NOTE: Some data cannot be copied from port
to port. Text under each address in
this manual is noted accordingly.
VOL VPROG - Moves to lower ports either assigning data
to a port or copying data from one port to
i3IlOtb~.
NOTE: Some data cannot be copied from
port
to port. Text under each address in
this manual is noted accordingly.
..- -.~~-.
MUTE ‘.
- recarries new data to the next higher port
by pressing the MUTE key. Press the MUTE
key again to enter the new data and advance
to the next higher port.
.
’ I
k. i
. .
6
To Next Page
Loading...
