Section 400
Issue 1 July 1990
S-DBS I’rogmmmin
g Instruct$oln;
.
HOW TO ENTER THE PROGRAM MODE
Attendant’s Phone:
-~--Eiisy $Ei2esSe programmin g is performed from an attendant’s telephone as follows:
l-ON/OFF
2. PROG
3. # #
4. One-touch key (PSD Key)
An attendant’s telephone is connected to extension ports 1 and 2 (extensions 10
or 11).
ON/OFF Key or POWER SETTING:
,.-.
There are three exceptions to programming from the attendant’s telephone. The
j
following addresses can only be programmed using the
POWER SETTING:
PSD
1
- addresses:
0005 (Outside lines)
0035 (SLT on-hook detection timer).
PSD 3 - address:
(lo-251
13 C (Hybrid system/dual port operation).
1. Power ON
2. Enter data
3. Power
OFF
4. Power ON
NOTE: C = Can be copied from port to port.
To Next Page
Loading...
