Section 400
Issue 1 July 1990
S-DBS Programming Instructions
v1.0
DATA TERMINAL PROGRAMMING
You can also program the system using a data terminal which gives you the ad-
vantage of checking the
final changes.
programmin
g steps on the display screen before making
At every stage in the programmin
g there are help screens available
@ the “H” kevonthete-nninalkeyb.oar_d.~
---. _
ENTERING THIi: DATA *E-AL PROGRAMMING MODE
Program the access code &om the key telephone fo; Data Terminal Program-
ming as follows:
1. CONF
2. #
,’ -
I .
.
3. 6
4. Program &digit ID code from the attendant’s phone.
5. Press HOLD
Access Data Terminal
Roe as follows:
1. Press ON/OFF key
2. #
3. Enter 99
4. Enter programmed 4-digit ID code
NOTE: The optional Station Message Detail Recorder (SMDR)
interface is required.
9
To Next Page
Loading...
