Section
400
Issue 1 JuIy 1990
S-DBS Programming Instructions
v1.0
0017#-(0
or l)#
SMDR TIMER - STARTING TIME DISPLAY FOR OUTSIDE CALLS
The start time for an outside caII appears on the display 15 seconds after the dial
signal is sent out. The 15-second default can be reset to 30 seconds.
The start time for an incoming calI appears on the display immediately after the
c~. is’ .answered.. -- -.
O#: 15 seconds
l#: 30 seconds
OOlS#-(0 or l)#
FLASH - REDIAL [AUTOMATIC)
The
REDIAL
key can automaticall
have been dialed and then redial x
cut off an outside line after one or more digits
e same numbers again.
However, if the system is connected to a PBX. re-program for No Automatic
FLASH
or the PBX wi.U go into ON-HOLD status when the
REDLAL
key is pressed.
O#:
No automatic
FLASH
.
A I4 .
0019#-(0, l-4)#
OUTSIDE LINE FLASH TIMER - OFF-HOOK (MANUAL)
Sets the timer to temporariIy release the outside line by pressing the
FLASH
or
REDLAL
key.
O#: 0.5
second
l#: 1 second
2#: 1.5
seconds
3#: 2
seconds
4#:
3
seconds
To Next Page