Section 400
Issue
1
July 1990
S-DBS Programming Instruct+oln.
.
0035#-(0,1-5)#
SLT ON-HOOK (AUTOMATIC) DETECTION TIMER
Set the line flash on an SLT to either Line
FLASH
or disconnect when the hook
button is pressed lon er or less than the time set for a Iine
FLASH.
(referred to as
the hooking operation.
4
No Detection Line Flash Disconnect
O#: No detection
l#: Less than 250ms
2#: Less than 250ms
3#: Less than 250ms
4#:
Less than 250ms
5#: Less than 250ms
250 - 500 ms Over 500 ms
250 - 1000 ms Over 1000 ms
250 - 1500 ms Over 1500 ms
250 - 2000 ms Over 2000 ms
250 - 3000 ms Over 3000 ms
NOTE: Can only
be
set usin the POWER SETTING. See‘
page 7 in this manu 3 for instructions.
0036f-(0
or 1)#
SLT OUTSIDE LINE HOLD
An outside Line caU on your extension can be put on System Hold or Exclusive
Hold.
O#: Svstem hold
l#: Exclusive hold
0037#-(0
or l)#
SLT INTERCOM CALL RING PATTERN
O#: Internal rim? signal nattem
I#: Same as incoming ca.II
signal
pattern
.
33
To Next Page