111
Troubleshooting
and Reference
Notes:
• If pressing the [REC] button or entering a recording trigger fails to start
recording, the [REC] lamp blinks at a high rate.
• The [BUSY] lamp blinks when accessing the P2 card immediately after
opening or closing the recorder’s P2 card slot cover.
Indicator Lamps and Recorder Status
(continued)
∗1 Inserting a P2 card that displays a “RUNDOWN” On Screen status display (see
“Viewing Live Video → Viewing the status of this unit” on pages 60, 61) will
cause the [READY] lamp to blink.
∗2 The [REC] lamp normally blinks under the following conditions:
• When there is little space left (about 30 minutes or less) on a P2 card
• When the number of files recorded on the P2 cards inserted in slots 1 and 2
totals over 19,000 (up to 20,000) files
• When the maximum number of recording files per day approaches (depends
on format type). See “Format” on page 86 for details.
• When the remaining recording days is less than 5% of the total recording days
of all P2 cards inserted in P2 card slots 1 and 2.
∗3 For details on how to run the PC application, refer to the operating instructions
supplied with the PC application.
∗4 If the error is related to the status of the P2 card, the status will appear in the
status display of the On-Screen. Refer to “Viewing Live Video → Viewing the
status of this unit” on pages 60 and 61, or contact your supplier.
To Next Page
Loading...
