Panasonic AG-CPD15P - Location and Name of Recording Files 31 Recording Error Warnings

32
On Recording
(continued)
When the recorder detects that it cannot properly record audio or video, it will
output the warning signals described below via GPIO9 (25-pin [GPIO/SERIAL]
connector).
Recording Error Warnings
Data output via GPIO9
∗1 A recording error indicates any of the following conditions.
• Cannot record (a detailed description of examples follow)
- P2 card slot cover is open
- No recordable P2 card is inserted or it is not recognized
- No more P2 card space available
- The write-protect switch of the P2 card is set to “PROTECT”
- When an error is detected on a P2 card and recording is no longer possible
- When a new unformatted 16 GB or higher capacity P2 card is inserted
- When a 16 GB or higher capacity P2 card is inserted and the maximum
number of recording days or files has been exceeded
- When an administrator setup is started or is going on
- When [PowerOff Time] (see “PowerOff Time” on page 75) is set to “AUTO”
and the engine switch is set to the LOCK (OFF) position
• Cannot recognize video signal from the camera
∗2
Unlit : Output to GPIO9 is low (output voltage 0 V)
∗3 Lit : Output to GPIO9 is high (output voltage 5 V)
∗4 Fast blinking: Output to GPIO9 repeatedly cycles between low → high → low
(250 ms cycle)
Item
When not recording
During
recording
When an error
occurs
∗
1
GPIO9 for Rec GPIO9 for Error
DISABLE DISABLE
Unlit
∗
2
Unlit
∗
2
Unlit
∗
2
DISABLE ENABLE
Continued
(fast blinking when
recording error was
the prior status.)
Unlit
∗
2
Fast blinking
∗
4
ENABLE DISABLE
Unlit
∗
2
Lit
∗
3
Unlit
∗
2
ENABLE ENABLE
Continued
(fast blinking when
recording error was
the prior status.
Otherwise Unlit.)
Lit
∗
3
Fast blinking
∗
4