Panasonic AG-CPD15P - Trigger; Osd

80
OSD
OSD
Use this function to set whether the
On-Screen Display appears on the
screen and is included in record files.
Setting : ON, OFF
Display Position
Use this function to set the display
position for the On-Screen Display on
the screen and in record files.
L-Upper : Upper left
R-Upper : Upper right
L-Bottom : Lower left
R-Bottom : Lower right
• In NONE mode
H : High-edge trigger
L : Low-edge trigger
SPEED : Detects vehicle speed
(GPIO8 only)
Notes:
• When SPEED is selected, [Printable]
becomes “–” and cannot be modified.
No screen is displayed, either.
•
Check the [Speedpulse] setting
described on page 84 before selecting
SPEED. Setting SPEED to ON using
an incorrect [Speedpulse] setting will
generate an abnormal trigger.
< Printable >
Assign characters to be used in the
OSD display.
Setting: A to Z, –, OFF (no display)
Note:
The value set by <Printable> appears
when the state triggered by <Detection>
prevails. However, only when a value
“B” is set for <Detection>, the value set
by <Printable> will appear during a high
state.
Administrator Setup
(continued)
Trigger
GPIO
Use this function to turn GPIO on or off.
Setting : ON, OFF
Trigger1 to 8
< Action >
Enter actions for detection of trigger
signals (GPIO1–8). Enter “NONE”
for triggers that will not be used.
REC: Record
STOP: Stop
AUTOZOOM: Automatically zooms
in/out or pauses
CAM1: Selects [CAMERA1]
connector input
CAM2: Selects [CAMERA2]
connector input
CAM1REC: Records video input to
[CAMERA1] connector
CAM2REC: Records video input to
[CAMERA2] connector
CAM1LED:
Changes the status
setting (on/off) of the
[REC] lamp on a Color
Camera connected to the
[CAMERA1] connector.
NONE: No operation.
< Detection >
Enter conditions for detection of
trigger signals (GPIO1–8). Choice
of detection method depends on the
setting selected by <Action>.
•
In REC, CAM1REC and CAM2REC
modes
H : High-edge trigger
Level H : High-level trigger
L : Low-edge trigger
Level L : Low-level trigger
B : Both-edge trigger
• In CAM1, CAM2, CAM1LED,
AUTOZOOM and STOP modes
H : High-edge trigger
L : Low-edge trigger
B : Both-edge trigger