26
The Memory Card Video Recorder
can record up to two audio channels
(Audio1 and Audio2). Out of the
three audio input connectors on the
rear panel ([AUDIO IN 1, 2], and [IN
CAR MIC]), the signal of the source
connected to the [AUDIO IN 1]
connector will always be recorded
on the Audio1. For the Audio2, you
can select either the sound from the
[AUDIO IN 2] connector or the [IN CAR
MIC] connector. This selection is made
using the Remote Control Panel.
The following two audio recording
modes are available: INCAR and
WMIC
Audio sources when recording
INCAR
Audio input at the [IN CAR MIC]
connector is recorded on the second
audio channel (Audio2).
WMIC
Audio input at the [AUDIO IN 2]
connector is recorded on the second
audio channel (Audio2).
On Recording
(continued)
The recorder automatically starts
recording when it is powered on.
Also when the recorder is operating
with the [PowerOff Time] setting,
recording will start automatically when
the recorder is turned on.
Power-on recording
To Next Page
Loading...
