18
(5) Remove the key.
(5) Remove the key.
P2 card Insertion and Removal
(continued)
(4) Close the P2 card slot cover.
Return the P2 card slot cover to its
original closed position and press
the section marked
PUSH
.
When you close the P2 card slot cover
after inserting a P2 card, the [READY]
lamp indicates the recorder status (see
“Indicator Lamps and Recorder Status”
on page 110).
Removing a P2 card
(2) Raise the Eject button.
(1) Open the P2 card slot cover
(see previous page).
(3) Push the Eject button so that
the P2 card pops out.
(4) Close the P2 card slot cover
(see top left of this page).
Notes:
•
If a P2 card was removed while it
was being accessed, the files may be
corrupted. Refer to “Restoring Files”
on page 71 to restore corrupted files.
• If a P2 card was removed while it
was being accessed, the P2 card
slot may be disabled. When the
recorder senses a disabled slot, it
may reboot itself automatically.
Note:
The [BUSY] lamp blinks for a few
seconds when the P2 card slot
cover is opened. Make sure that
the blinking has stopped before
removing a P2 card.
To Next Page
Loading...
