78
Administrator Setup
(continued)
Skip Target
Use this function to set the skip
location (the amount of time that is
skipped) when the [Skip back] or [Skip
forward] button is pressed.
Trigger / Marker
Playback jumps to the trigger
position (one per file) at which
recording began, or to a bookmark
position, whichever found earlier.
However, no trigger position can
exist in automatically divided files.
Setting : YES, NO
Head of File
Use this function to move to the
beginning of a file during playback.
Setting : YES, NO
Notes:
• When both [Trigger/Marker] and
[Head of File] are set to “YES”,
playback will restart from the first
trigger or bookmark that appears or
restarts from the beginning of the
file.
• [Trigger/Marker] and [Head of File]
cannot both be set to “NO”.
Programed Rec
Use this function to set recording to start
and stop every day or on a specified
day of the week.
Daily
∗
Makes daily recordings from the set
start time to the set stop time.
ON
:
Start time and stop time can be set.
– : No setting is available.
Note:
When [Daily] is set to “ON”, the
[Mon] to [Sun] field changes to “–”
and no setting can be made.
Mon to Sun
∗
Makes recordings from the set
start time to the set stop time on a
specified day of the week.
ON
:
Start time and stop time can be set.
A time for the next day can be set.
– : No setting is available.
Notes:
• The start time must be set to a
time that comes at or later than
the stop time for the previous day.
•
When the stop time is set to the
same time as the start time or to a
time prior to the start time, the stop
time will be set for the next day.
• Even at a time outside of the set
start time and stop time period,
recording will start if the recording
start criteria are met, for example,
when a recording trigger is input
or the [REC] button is pressed.
• Programmed recording will start
if the power is turned on in the
period between the start time and
stop time.
• If auto maintenance is performed
during programmed recording,
recording will be interrupted for 40
to 50 seconds.
∗ The <Duration> field indicates the time period from start time to stop time.
To Next Page
Loading...
