Panasonic AG-CPD15P - Page 113

113
Troubleshooting and Reference
Recording
Symptom Remedy
Cannot start recording.
Or a recording error
warning appears.
• Is a P2 card inserted in a P2 card slot?
• Is the P2 card slot cover closed?
• Is there any free space on the P2 card? Check
the remaining space, and upload files to clear
some space.
• Make sure that the write-protect switch of the P2
card is not set to PROTECT.
•
Check if a 16 GB or higher capacity P2 card was
formatted in this unit. A 16 GB or higher capacity
P2 card whose folders have been modified on a
PC must be reformatted in this unit.
• Are the [GPIO/SERIAL] connector or recording
trigger criteria set correctly?
•
Check whether the recorder is set to administrator
setup status.
• Check whether the correct cables have been
connected to the video input connectors.
Recorded data have
become totally or partially
unusable.
• A power outage or power cable (included in the
separately sold Cable Kit) disconnection during
recording may damage the P2 card or corrupt
data on a P2 card. Never turn the power off
while recording to a P2 card.
• Do not insert or remove a P2 card when another
P2 card is being accessed as this may damage
the P2 card or corrupt data on the P2 card.
•
Corrupted data may be restorable (see “Restoring
Files” on page 71 for details).
Troubleshooting
(continued)