IN CAR MIC
CAMERA 1
CONTROL PANEL
GPIO/SERIAL
USB
GPS-ANT.
(OPTION)
CAMERA 2
AUDIO IN
VIDEO OUT
AUDIO OUT
USB memory device
(commercially available)
USB Extension
Cable (included
in the separately
sold Cable Kit)
(included in the
separately sold
Cable Kit)
: Connect to a terminal that
always supplies power
through a fuse, regardless
of whether the engine is
on or off
Connect the signal line
through a fuse to the
ACC line or to the
output terminal of a
timer device.
This is the input line for a signal or
vehicle speed pulse
∗
Recording status output via
GPIO9
Connect to a commercially
available radar gun
LAN cable (cross
cable, commercially
available)
Remote Control Panel
(separately sold)
Audio input
(mic level)
GPS antenna
(included in the
separately sold
Cable Kit)
Audio input 1
(line level)
Audio input 2
(line level)
Color Camera
(separately sold)
Power cable
Camera
(commercially
available)
Camera cable
(provided with the
separately sold
Color Camera)
Trigger cable
(included in the separately
sold Cable Kit)
PC
(commercially
available)
Others: Input signal lines
White (SIGNAL):
Black
(GND: )
Red
(BATT: )
White:
Gray:
RS-232C:
Black: Connect to the negative
terminal (GND: ) of the battery
: Connect to the negative
terminal of the battery
16
∗ There are two types of vehicle speed pulse signals: digital waveforms (square
waves) and analog waveforms (AC waveforms). The recorder accepts only
digital waveforms. Ask your supplier about the connection procedure.
Connections
(continued)
To Next Page
Loading...
