Panasonic AG-CPD15P - Page 53

53
Operation Using the Remote Control Panel (separately sold)
7. To enter officer2, replace the
current USB memory device
with a USB memory device
containing data for officer2.
8. Use the [
, ] buttons to select
[Officer2].
9.
Use the [ , ] buttons to select
[Load] and press [ ] to confirm
the entry.
This registers officer2 and the name
and ID appear.
Note:
Long names and IDs may not be
displayed in full.
LIST mode
Open the menu on the LCD panel and
read in the officer data registered in this
unit from the Officer setup top screen.
For details on registering officer data,
refer to “Load Officer” on page 79.
1. Press the [MENU] button.
The Menu appears.
2. Use the [ , ] buttons to select
[Setup/Info] and press [ ] to
confirm the entry.
3. Use the [ , ] buttons to select
[Officer] and press [ ] to
confirm the entry.
The Officer setup top screen appears.
4. Use the [ , ] buttons to select
[Officer1].
5. Use the [ , ] buttons to select
[Select] and press the [ ]
buttons to confirm the entry.
A list of officers registered in this
unit appears.
6. Use the [ , ] buttons to select
an officer, (use the [
, ] buttons
to go between pages) and press
[ ] to confirm the entry.
The Officer setup top screen
appears when officer1 has been set.
7. Use the [ , ] buttons to select
[Officer2].
8. Use the [
, ] buttons to select
[Select] and press [
] to
confirm the entry.
A list of officers registered in this
unit appears.
Note:
Long names and IDs may not be
displayed in full.
9. Use the [ , ] buttons to select
an officer, (use the [ , ] buttons
to go between pages) and press
[ ] to confirm the entry.
The Officer setup top screen
appears when officer2 has been set.
Deleting entered data
1. Press the [MENU] button.
The Menu appears.
2. Use the [ , ] buttons to select
[Setup/Info] and press [ ] to
confirm the entry.
3. Use the [
, ] buttons to select
[Officer] and press [
] to
confirm the entry.
The Officer setup top screen appears.
4. Use the [ , ] buttons to select
[Officer1] or [Officer2].
5. Use the [ , ] buttons to select
[Delete] and press [ ] to
confirm the entry.
This deletes officer data selected in
Step 4.
Note:
Officer data cannot be deleted in
“AUTO mode”.
Setting up/Deleting Officer Data
(continued)