– 85 –
Chapter 4 Operation — Menu settings
[SDI+HDMI]
Outputs from the <SDI OUT> terminal and the <HDMI> terminal.
[AV+HDMI]
Outputs from the <AV OUT> terminal and the <HDMI> terminal.
(Factory setting: [SDI+HDMI])
[SDI OUT]
[OUTPUT SW]
Enables/disables the output from the <SDI OUT> terminal.
[ON] Outputs the video.
[OFF] Does not output the video.
(Factory setting: [ON])
[OUT FORMAT]
Selects the signal to output from the <SDI OUT> terminal. The items that can be selected differ depending on the [SYSTEM] menu → [FREQUENCY]/
[FILE FORMAT]/[REC FORMAT] setting.
[1920×1080p] Outputs in 1920×1080p.
[1920×1080i] Outputs in 1920×1080i.
[1920×1080PsF] Outputs in 1920×1080PsF.
[1280×720p] Outputs in 1280×720p.
[720×480i] Outputs in 720×480i.
[720×576i] Outputs in 720×576i.
(Factory setting: [1920×1080i])
@@
NOTE
t For the combinations that can be set, refer to “Format that can be output from the <SDI OUT> terminal” (page 164).
[3G-SDI OUT]
Sets the format of the 3G SDI signal output from the <SDI OUT> terminal. Can be set when the 3G SDI signal is output.
[LEVEL‑A] Selects the LEVEL-A method.
[LEVEL‑B] Selects the LEVEL-B DL method.
(Factory setting: [LEVEL-B])
[SD-SDI EDH]
Sets whether to superimpose EDH when output from the <SDI OUT> terminal is the SD signal (480i and 576i).
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [ON])
[SDI REC REMOTE]
Sets if the recording operation against the external equipment connected to the <SDI OUT> terminal (such as recorder) is to be controlled or not.
[ON] Controls the recording operation of the external equipment.
[OFF] Does not control the recording operation of the external equipment.
(Factory setting: [OFF])
@@
NOTE
t This cannot be set when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] is set to [INTERVAL].
[SDI OUT CHAR]
Sets whether to superimpose the character to the output from the <SDI OUT> terminal.
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
[SDI OUT ZEBRA]
Sets whether to superimpose the zebra signal to the output from the <SDI OUT> terminal. The settings of the zebra signal follow the zebra signal
settings in the [VIDEO OUT/LCD/VF] menu → [EI ASSIST].
[ON] Superimposes.
[OFF] Does not superimpose.
(Factory setting: [OFF])
@@
NOTE
t The setting is xed to [OFF] when the [SYSTEM] menu → [COLOR SETTING] is set to [V-Log].
To Next Page
Loading...
